Melitta solo and perfect milk support

Melitta barista solo support and perfect milk support

Learn how to set the correct water hardness, maintain the brewing unit, clean the Cappuccinatore, understand the warning lights and keep your machine producing consistently great coffee every day. Based on the official Melitta operating manual.

Set the correct water hardness
Use the supplied water hardness test strip and set the machine correctly. This ensures descaling reminders appear at the right time.
Replace the PRO AQUA filter every 2 months
If you're using a Melitta PRO AQUA filter cartridge, replace it every two months for the best taste and reduced limescale build-up.
Clean the Cappuccinatore after every milk drink
Milk residue dries quickly inside the frothing system. Flush and rinse the Cappuccinatore immediately after use to maintain smooth milk foam.
Remove and rinse the brewing unit regularly
The removable brewing unit should be taken out and rinsed under clean water regularly to keep coffee flowing properly and reduce build-up.
Empty the drip tray before it becomes full
Don't wait for overflow. Empty the drip tray and coffee grounds container whenever prompted by the machine.
Always use fresh cold water
Refill the water tank with fresh cold tap water rather than topping up old water to maintain coffee flavour and reliable brewing.

1 6

Why is my Melitta Solo & Perfect Milk not producing good milk foam?
The Cappuccinatore, milk tube or steam outlet may contain dried milk residue. Clean all milk components immediately after use and ensure the valve is set to the milk foam position before preparing milk.
When should I descale my Melitta Solo & Perfect Milk?
The machine will illuminate the descaling indicator when descaling is required. This timing depends on the water hardness setting, so it's important to configure the correct hardness during setup.
Can I remove the brewing unit for cleaning?
Yes. The brewing unit is removable behind the right-hand service cover and should be rinsed regularly with clean water to keep the coffee system working efficiently.

1 3

Melitta Solo & Perfect Milk Indicator & Fault Light Guide
Ready light illuminated – Machine is ready to brew coffee.
Ready light flashing – Machine is heating up or coffee is currently being dispensed.
Water filter light illuminated – Replace the Melitta PRO AQUA water filter.
Water filter light flashing – Filter replacement programme is running.
Water tank light illuminated – Refill the water tank.
Water tank light flashing – Refit the water tank correctly.
Drip tray / grounds container light illuminated – Empty the drip tray and coffee grounds container.
Drip tray / grounds container light flashing – Reinstall the drip tray and grounds container.
1 Bean indicator – Mild coffee strength selected.
Melitta Solo & Perfect Milk Indicator & Fault Light Guide
2 Bean indicator – Normal coffee strength selected.
3 Bean indicator – Strong coffee strength selected.
Bean indicator flashing – Refill the bean hopper. Flashing stops after the next brewing cycle.
Cleaning light illuminated – Run the cleaning programme.
Cleaning light flashing – Integrated cleaning programme is currently running.
Descaling light illuminated – Run the descaling programme.
Descaling light flashing – Integrated descaling programme is in progress.
Steam / milk light illuminated – Machine is ready to froth milk, or air is trapped in the system. Turn the steam valve until water flows to vent the system.
Steam / milk light flashing – Milk frothing or hot water dispensing is in progress.